US Robotics COURIER Instrukcja Użytkownika Pobierz pdf (Strona 146)

U.S. Robotics I-modem Command Reference

Querying • Page 12-17

Disconnect Reasons for Dial Security

I7 Display the product conÞguration. If you have a problem and call U.S.

Robotics' Technical Support staff, you may be asked to read this screen.

Table 12-3. Dial Security Disconnect Reasons

Disconnect

Reason Explanation

Mode

Incompatible

The I-modem hung up because both devices were not set to the same error-con-

trol setting.

No Prompting

in Non-ARQ

Prompting was enabled, but the I-modem hung up because the originating

device was set for error control, and the answering device was set for non-error

control. The answering device cannot prompt when it is set for non-error control.

No Prompting

in Sync

(External

I-modems only)

The originating device did not send an Autopass password, and the answering

device cannot prompt for a password in any synchronous

mode.

Non-ARQ Mode The I-modem hung up because the originating device was set for error control

and the answering device was set for non-error control.

Prompting Not

Enabled

The I-modem hung up because the originating device did not send an Autopass

password, and prompting wasn't enabled.

Security Abort The I-modem hung up because it received an invalid password three times.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 307 308

Brak uwag

US Robotics COURIER Instrukcja Użytkownika Strona 146