US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Instrukcja Użytkownika Pobierz pdf (Strona 54)

56K Softmodem

Command Reference

- 48

Table 3-88: +GCAP Responses

Note:* ITU-T recommendation V.250 (05/99) identifies an additional response (+MV18S) that is not

included with the 56K Softmodem. +MV18S is for V.18 modulation control. For more information refer

to ITU-T recommendation V.250 (05/99).

+GCI=<T.35_country_code>—Country of Installation

Use this command to set the modem country code. ITU-T Recommendation T.35

defines the country codes and the country names. Table 158 on page 82 has a

complete list of the T.35 country codes.

Result codes:

OK if <T.35_country_code> = valid country code as defined by Table 158.

ERROR if <T.35_country_code> does not equal valid country code as defined by

Table 158.

Table 3-89: +GCI Extended Syntax Commands

+GMI—Manufacturer Identification

+GMI is an extended syntax command. It returns the modem manufacturer

and either the OK or ERROR result code. The +GMI=? syntax returns an

ERROR result code. The other two forms return an OK result code.

Result codes:

OK when using the +GMI or +GMI? syntax.

ERROR when using the +GMI=? syntax.

+GCAP Responses* DCE Control Standard Description

+FCLASS T.class 1, +F Class 1 FAX DCE control

+MS +M commands Modulation control: • +MS • +MR

+ES +E commands Error control: • +ES • +EB • +ER •

+EFCS • +ETBM

+DS +D commands Data compression • +DS • +DR

Command Description

+GCI=<T.35_country_code> Set the country code.

+GCI? Display the current country code setting.

+GCI=? Display all supported country code settings.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 107 108

Brak uwag

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Instrukcja Użytkownika Strona 54